I might be wrong but the smell and taste associated with street amphetamines comes from the leftover freebase.I suspect they leave it on purpose to “flavor” the fillers.
All methods posted here yield relativley clean amphetamine freebase, which you (hopefully) further purify by steam distillation(before precipitation ofcourse) and or acetone wash after precipitation.Question dosen’t really make sense.Amphetamine is amphetamine, either l or d, there is no “apaan...
I don’t know if you are aware but gallium forms amalgams with metals, including Al.Everything you said about Hg in the first paragraph can be applied to gallium.Please correct me if I’m wrong, anyone.
I read about liah, I don’t wanna work with it at the moment, too dangerous in my setting, And...
Well, I would think in general a reaction that runs to the end at a constant say 60 C, compared to a reaction that quickly goes to 80 C, then is cooled, heated again etc will have a better yield.Just my thinking, maybe somebody can correct me.Have you tried straining on a loose mesh and not...
Are you precipitating with water? The sulphate form is water soluble.From what I understand an anhydrous or nearly anhydrous solvent should be used.
How are your yields?
No, mixture was used at room temp with only a little agitation of the container beforehand.I will do this next time and report back.I will also source some fresh conc. orthophosphoric acid to compare.Thanks mr patton.
Appropriate plastic barrel, cooling by barrel-in-barrel.Condenser with a pipe inside a bigger pipe, the outer section insulated from the system with silicone or something else appropriate, fitted with water in and water out, really easy.
Or batch reacor if budget allows, mister Patton has a...
Coincidence has it I tried h3po4 yesyerday.I had 50ml H3PO4 in which 2 additional gram of it’s anhydryde were dissolved.I drove reaction to the end, extracted ipoh with xylene, dried over anhydrous mgso4 for 10-15 minutes.The somewhat dry xylene with freebase was transfered to a clean dry...
At 30g rno2 and paper thin cut foil is a surefire recipe for overflow hehe.When I go over 5g of substrate i ball up my alu by hand, making not too loose not too tight balls.Helps keep the reaction under control, may need some heat to drive it to the end, but not all the time.